The Silicone Ring Sealing Effect Is Poor, What Is The Reason For Not Achieving The Sealing Effect?

There are many main reasons that affect the service life, but in any seal, the silicone ring will be affected by several common phenomena.

The force size affects or the compression is permanent, and the installation method is different, such as plane, concave and convex groove or groove, etc. The installation method of each product is different, which is likely to lead to uneven force and force center deviation, resulting in a heavy side and light side resulting in compression permanent deformation after long-term overloading. When the sealing silicone ring is removed again, there is likely to be deformation, so it is necessary to control the balance and the degree of stress evenly integrated at the same time of installation.

Incorrect product size resulting in gap deformation:

The gap problem can be divided into several factors, one is because of the material material problem, many silica gel materials due to the formula of poor resilience, insufficient tensile force caused by the problem in the process of use is not strong enough to leak gaps, silicone ring processing manufacturers processing problems: for example, the product is brittle resulting in the silicone product roll thickness is relatively thin is prone to this problem, The soft product leads to the internal bulge of the rubber material, and the gap problem occurs after the deformation of the long-term tensile pressure.

Product weakness or brittleness lead to functional failure, many times is not the structural problem of materials and products, but the quality standards of products are affected in the production and processing process of silicone rubber products manufacturers, such as processing does not understand the hardness and softness requirements of products, and the processing time will be extended leading to the product is too brittle in the process of installation. Or if you want to improve the processing efficiency, the product becomes soft, resulting in deformation when the product is stressed.

Product weakness or brittleness lead to functional failure, many times is not the structural problem of materials and products, but the quality standards of products are affected in the production and processing process of silicone rubber products manufacturers, such as processing does not understand the hardness and softness requirements of products, and the processing time will be extended leading to the product is too brittle in the process of installation. Or if you want to improve the processing efficiency, the product becomes soft, resulting in deformation when the product is stressed.